Thingiverse
14-19mm Combination / Ring Spanner Pegs
von PhillyDee
175
Downloads
115
Likes
1
Makes
A simple hanging holder for Combination Spanners. This fits the 14-19mm half of the set.
Holds 2x Spanners.
Colour the end in, or run a dual colour print.
Make this nice and strong, ideally ABS or PET-G with a high infill and wall count.
https://www.thingiverse.com/thing:6152279 - The 6-13mm version.
The holes on the rear fit a standard Bott Perfoboard. Either bolt to the back, or affix through the holes. There isn't anything to locate from, so can also be fitted to a shadowboard or a wall.
Holds 2x Spanners.
Colour the end in, or run a dual colour print.
Make this nice and strong, ideally ABS or PET-G with a high infill and wall count.
https://www.thingiverse.com/thing:6152279 - The 6-13mm version.
The holes on the rear fit a standard Bott Perfoboard. Either bolt to the back, or affix through the holes. There isn't anything to locate from, so can also be fitted to a shadowboard or a wall.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
