Thingiverse
Hobby sized hand drill.
by forrozza
122
Downloads
77
Likes
0
Makes
Inspired by a push drill and bevel gear assembly i saw on thingiverse. I wondered if i could make a lightweight hand-cranked version of my vintage hand drill. The result is a small hobby drill which takes 2mm to 6mm bits. Smooth running because it uses bearings and the tolerances are fine. this is a tough little drill.
you'll need
2x M3 25mm bolts, washers & nylock nuts.
6x 14mm x 5mm bearings (inner 8mm).
Main body should be at least 50% infill, and all pins, spindles, screws, gears
you'll need
2x M3 25mm bolts, washers & nylock nuts.
6x 14mm x 5mm bearings (inner 8mm).
Main body should be at least 50% infill, and all pins, spindles, screws, gears
Sign in to leave a comment
Sign in