Wanhao Duplicator i3 V2 Wire / Cable Shroud

***Please note that this will require using an M4 x .7 tap to thread 1 existing hole on the rear of each top X axis bearing carrier and you will need 2 - M4 x 6 or 8 button/cap head screws***

I tried a different wire cover that required rotating my extruder stepper motor (http://www.thingiverse.com/thing:1473926) but I did not have enough slack wire to do it so I came up with my own. I grabbed the logo from this thing: http://www.thingiverse.com/thing:1359039.

You will need to tap the inn