3D Print of Fasta lighta II

Saturn 3 Ultra. I fixed it by adding a 4mm hole at the base of the seat into the rear hollow segment to relieve suction. It is covered by the pilots chair and is not visible once assembled. Really disappointed to lose an entire plate of resin to this oversight. The only parts to succeed were those shorter than the hollow. The pilot, engine block, jet plume and the gun barrels. The suction force from this thing was truely impressive, I have never seen such warpage before, I had hoped I could just use the wonkey-ness to make it feel orky but structurally it was unusable as no two parts could fit together. I recommend using lychee slicer instead of chitubox. It's suction cup detection would have alerted on this during supporting. A bit upset really but I suppose I should have just supported it myself.