Thingiverse
FLSun Delta Ball Joint
by vangalvin
83
Downloads
70
Likes
0
Makes
Delta Printer Ball Joint Housing.
I have an FLSun Delta Printer and have had some minor issues with the ball joints on the arms so have decided to pull the balls out and make a new housing for them.
The balls are approximately 8mm in diameter and snap in to the housing quite well.
I used ABS to print them but eventually will replace this with Nylon.
Removing the balls from the old aluminium casing is prety easy, I used a small bearing with an ID that was larger than the ball, then a bo
I have an FLSun Delta Printer and have had some minor issues with the ball joints on the arms so have decided to pull the balls out and make a new housing for them.
The balls are approximately 8mm in diameter and snap in to the housing quite well.
I used ABS to print them but eventually will replace this with Nylon.
Removing the balls from the old aluminium casing is prety easy, I used a small bearing with an ID that was larger than the ball, then a bo
Sign in to leave a comment
Sign in