UPDATED E3D Direct Drive Bracket for Flashforge Creator Pro

UPDATED VERSION

This one gives a bit more room for the fan and allows the heater block wires to come out the back and not get pinched.

This will allow you to use a E3D V6 and Titan extruder on your FFCP ( NOT TESTED ON OTHER MACHINES)

Used a pancake stepper motor as a standard one hits the back of the machine but you can tape a block on the left Y carriage to hit the end stop if you want.

In S3D set your offsets to 7.50 and -7.50 as per the picture.

Up your extraction rates by