Thingiverse
Tronxy X3 Supercooler - hot end fan shrouds
by idig3d
352
Downloads
247
Likes
11
Makes
**UPDATE:** Check out this [Mitten Cooler](https://www.thingiverse.com/thing:2792412) newer design I just released. Should work well and need only a 5015 fan.
My stock built Tronxy X3 printer's hot end could not go above 205ºC. The stock design cools the heater block too much. I wanted to printer higher temp >220ºC filaments and could not with the stock printer. So here is my solution.
It reuses the screws from the hot end radiator, but they only work if you remove the washers.
It's de
My stock built Tronxy X3 printer's hot end could not go above 205ºC. The stock design cools the heater block too much. I wanted to printer higher temp >220ºC filaments and could not with the stock printer. So here is my solution.
It reuses the screws from the hot end radiator, but they only work if you remove the washers.
It's de
Sign in to leave a comment
Sign in