Thingiverse
2.5 SSD Array
von ESmfg
6
Downloads
5
Likes
0
Makes
Five-bay SSD Array for 2.5inch drives. It is intended for use with external drives. Hot swap slots are dovetailed.
The file for the drive racks are oriented vertically. this allows for the printing of all five in 13+/- hours. Be sure support overhang is at least 65 (Cura) and set to everywhere, 1% support infil.
The Array box should take about 11+/- hours.
The file for the drive racks are oriented vertically. this allows for the printing of all five in 13+/- hours. Be sure support overhang is at least 65 (Cura) and set to everywhere, 1% support infil.
The Array box should take about 11+/- hours.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!