BLTouch Holder for Tevo Tarantula

Hi,

if you have the stock dual hotend for the Tevo Tarantula and the wonderfull Fang Duck :p you may are worried about where to place the BLTouch levelling sensor without losing printable area.

Here is the solution !!

This support is design to be installed behind the heat sink. just in place of the spacer ! the wire should go thru the hole of the X-carriage.

you will need 2 Allen screw M3x10mm and 2 nuts M5. other parts remain unchanged.

Fill free to comment !

Have a good print