MOSFET Holder for Anet A6 / A8

This is my own MOSFET Holder for my Anet A6. It should fit on the Anet A8 too.
The MOSFET Holder uses the standoffs from the microcontroller for mounting.

There are two versions:

1) for a angled USB type B connector

2) for an straight USB type B connector

I used the following MOSFET:

https://de.aliexpress.com/item/3D-Printer-Parts-General-Add-on-Heated-Bed-Power-Expansion-Module-High-Power-Module-expansion-board/32765683570.html?spm=2114.13010608.0.0.JyTlBI

The requiered cabl