Anet A6 A8 Rear frame hold down Bracket

To hold the rear frame down on an Anet A6/A8 on to a base board. Not tested on an A8, but I believe its the same design. Someone could tell me.

Printed in two parts for ease of printing. Designed for a 25mm *3.5mm Screw. Will take upto 40MM though as it's over designed.

The hole in the top part and the 2 holes in the bottom part need opening out with a 3.5mm drill. I think it makes a better stronger piece.

Fit the top part to the bottom (Note the guides to hold it in positi