Thingiverse
Trinus Filament Guide Ball Bearing
by jdmoto
57
Downloads
30
Likes
0
Makes
Please read the following notes.
InputA&B (Enclosure guide):
This is a 2pc snap in unit. This encapsulates 5 magnetic 3mm ball bearings. place both on the same build to help cool down during build. For best result use 0.15mm layer and slower speed, this has a single wall snap in feature.
Bottom Section & Top Cover (Extruder guide):
This is a 2 pcs snap in design. This again uses 5 magnetic 3mm ball bearings. I suggest using support to build both, but make sure on the bottom section p
InputA&B (Enclosure guide):
This is a 2pc snap in unit. This encapsulates 5 magnetic 3mm ball bearings. place both on the same build to help cool down during build. For best result use 0.15mm layer and slower speed, this has a single wall snap in feature.
Bottom Section & Top Cover (Extruder guide):
This is a 2 pcs snap in design. This again uses 5 magnetic 3mm ball bearings. I suggest using support to build both, but make sure on the bottom section p
Sign in to leave a comment
Sign in