Thingiverse
E3D Ultimaker Direct Titan Upgrade
by jamesla
153
Downloads
111
Likes
0
Makes
THERE IS A NEW VERSION: https://www.thingiverse.com/thing:2749539
Want to add a Direct(ish) Titan Extruder to your Ultimaker 2? Then this is for you! You will need to add a length of PTFE (4mm OD) from the extruder down into the hot end. I would recommend running a 4mm drill through the hole in the Titan fixture.
There are some cable tie mounts for all the electronics as they will not fit through the head anymore.
Important note:
Remember to fit the knurled long bolts BEFORE the motor a
Want to add a Direct(ish) Titan Extruder to your Ultimaker 2? Then this is for you! You will need to add a length of PTFE (4mm OD) from the extruder down into the hot end. I would recommend running a 4mm drill through the hole in the Titan fixture.
There are some cable tie mounts for all the electronics as they will not fit through the head anymore.
Important note:
Remember to fit the knurled long bolts BEFORE the motor a
Sign in to leave a comment
Sign in