Thingiverse
Fan Duct with suport
by stefi01
10
Downloads
8
Likes
0
Makes
Had problems printing this with cura and slic3r so added permanent support and these printed fine in cura
the file - e3d hypercube fanduct has a thicker layer inside the top bridge where it slots into the main mount, the rest is untouched, the settings i used were in cura, 0.15mm layer thickness, 60mm sec speed, no support
the file - e3d hypercube fanduct has a thicker layer inside the top bridge where it slots into the main mount, the rest is untouched, the settings i used were in cura, 0.15mm layer thickness, 60mm sec speed, no support
Sign in to leave a comment
Sign in