Thingiverse
Tevo Black Widow extruder spacer
by tuxcat
28
Downloads
25
Likes
0
Makes
Spacer block to move the stock extruder away from the carriage plate by 18mm. This gives enough clearance that the extruder motor can move past the frame allowing you the full printable area! You will need longer screws for this block. I used 50mm and just cut them down a little with a Dremel tool.
I also moved the extruder to the center by drilling out the two center holes (lower set of holes in the top half of the plate) to about 1/4" so the screws could line up with the holes in the extr
I also moved the extruder to the center by drilling out the two center holes (lower set of holes in the top half of the plate) to about 1/4" so the screws could line up with the holes in the extr
Sign in to leave a comment
Sign in