Thingiverse
FolgerTech FT5 Aeroshuttle
37
Downloads
18
Likes
0
Makes
This is a replacement shuttle for the FolgerTech FT5 printer. It's designed for the E3D Titan Aero extruder, so it's got nothing under the stepper motor, allowing for the max possible bed clearance. With a V6 heat block you get about 25mm space for a fan duct.
The fan duct I've included was designed to try to minimize disruption due to clips on the bed. It does lose a few mm on the X axis, but it's not too bad.
If you choose to use the part cooling fan, it was designed to fit with these fa
The fan duct I've included was designed to try to minimize disruption due to clips on the bed. It does lose a few mm on the X axis, but it's not too bad.
If you choose to use the part cooling fan, it was designed to fit with these fa
Sign in to leave a comment
Sign in