Thingiverse
Anet A6 Double Mosfet-Mount (no drilling)
174
Downloads
100
Likes
5
Makes
This is a easy way to mount two mosfets (one for the hot bed and one for the hot end) to the frame of the anet a6. I designed it by myself and wanted it to look clean and with good cable routing options.
You only need to print 1x the main part and 2x the little clip, which will clamp the upper board.
Only a few screws and nuts are needed. (these were left by my printer build)
Under the lower board is a cutout for the cables of the upper.
The mosfet-mount is attached to the frame by four
You only need to print 1x the main part and 2x the little clip, which will clamp the upper board.
Only a few screws and nuts are needed. (these were left by my printer build)
Under the lower board is a cutout for the cables of the upper.
The mosfet-mount is attached to the frame by four
Sign in to leave a comment
Sign in