Thingiverse
Prusa i3 MK2 Top Filament Mount
by DBaysinger
5
Downloads
4
Likes
0
Makes
I created this mounting system so I could change out the filament easily on the Prusa i3 MK2. This design allows the filament to unroll naturally with barely any friction. It also puts a lot less pressure on the x-motor so it doesn't have to apply so much force on the filament roll.
I use this design with a 5mm all thread and my universal filament spool shown in the link below.
http://www.thingiverse.com/thing:2303240
Overall, I can take the spool off a lot easier and my prints have a lot l
I use this design with a 5mm all thread and my universal filament spool shown in the link below.
http://www.thingiverse.com/thing:2303240
Overall, I can take the spool off a lot easier and my prints have a lot l
Sign in to leave a comment
Sign in