Thingiverse
Mosfet Mount Snap on Board fits Tronxy P802
47
Downloads
27
Likes
1
Makes
This remix is for externally mounting a separate MOSFET to switch power to the heated bed or extruder. By removing the load from your controller we are able to prolong it's life and are allowed the option to run more power though to the powered device away from, and isolated from your controller in order to get the job done. Mounting holes are located where pre-existing holes exist on a P802 but can be mounted anywhere you can drill two 3mm holes. Snap fasteners will save you from further pilfer
Sign in to leave a comment
Sign in