Thingiverse
Motor mount for profile RC plane (5mm)
by Qraft_RC
24
Downloads
19
Likes
0
Makes
Motor mount for profile RC plane (5mm). This is heavy duty and suitable for larger motor.
Use 20% to 50% infill for secure screwing
Print it upside-down as shown in the picture
Use a skirt
the gap is 5.4mm to prevent crushing the foam, as such, epoxy is recommended, but UHU Por is preferred if it fits the foam pieces.
Center the motor and mark out the screw holes BEFORE glueing it on.
Drill the holes AFTER glueing it on.
Use 20% to 50% infill for secure screwing
Print it upside-down as shown in the picture
Use a skirt
the gap is 5.4mm to prevent crushing the foam, as such, epoxy is recommended, but UHU Por is preferred if it fits the foam pieces.
Center the motor and mark out the screw holes BEFORE glueing it on.
Drill the holes AFTER glueing it on.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in