Thingiverse
hictop deported extruder
by stilther
11
Downloads
0
Likes
0
Makes
for put the extruder motor on the frame of your hictop 3d printer, with support for connector and place to put a filament cleaner.
You need 2 x M5 x10mm and 3 x M3 screw
you can use the 2 original piece of the extruder
I take 1 hour to make this 3 parts and assembled them.
you can just print the motor support and put your own ptfe support, for exemple a mk8 extruder.
To block the connector you can use the little piece, remove the cap of the connector and put the to screws in holls
You need 2 x M5 x10mm and 3 x M3 screw
you can use the 2 original piece of the extruder
I take 1 hour to make this 3 parts and assembled them.
you can just print the motor support and put your own ptfe support, for exemple a mk8 extruder.
To block the connector you can use the little piece, remove the cap of the connector and put the to screws in holls
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in