Thingiverse
Anet A8 Electronics Case (Raspberry Pi Zero (W), DC Converter + Mainboard)
by miege95
42
Downloads
19
Likes
0
Makes
I wanted to use a raspberry pi zero (w) as I had already lying one around and also it is much cheaper and smaller than the normal pi.
Also I didn't need a relay (yet) so I included mounts for a small DC 12V to 5V USB converter (which I also had lying around from a car project), to power the PI directly from the printers PSU. (I was getting fed up to unplug my bedside lamp and phone charger every time I was going to print something because I had no spare power strip :D )
Cables need a little
Also I didn't need a relay (yet) so I included mounts for a small DC 12V to 5V USB converter (which I also had lying around from a car project), to power the PI directly from the printers PSU. (I was getting fed up to unplug my bedside lamp and phone charger every time I was going to print something because I had no spare power strip :D )
Cables need a little
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in