Thingiverse
HyperCube, E3D mount without blowing
by saschai
26
Downloads
10
Likes
0
Makes
I'm slowly collecting a new HyperCube
Last night I printed the carriage of the X-axis.
A few hours earlier was an update.
I realized this, only after the end of printing :))))).
I print ABS plastic, without blowing.
I used the idea of this holder https://www.thingiverse.com/thing:1876861 and made holder for new versions X carriage.
Adapted for ABS printing with plastic.
I'll check in live only next week, but there should not be any problems!
Last night I printed the carriage of the X-axis.
A few hours earlier was an update.
I realized this, only after the end of printing :))))).
I print ABS plastic, without blowing.
I used the idea of this holder https://www.thingiverse.com/thing:1876861 and made holder for new versions X carriage.
Adapted for ABS printing with plastic.
I'll check in live only next week, but there should not be any problems!
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in