Thingiverse
Anet A8 Switch Panel
by rpatten
12
Downloads
6
Likes
0
Makes
A switch panel I made for my Anet A8. Holds 3 Standard 3/4" Rocker Switches. Illuminated or not. and has a hole on the back to feed the wires in and out.
Mounts on the top of the Anet A8 with 3M VHB double sided tape, and upper section is built at an angle to mount the Official Raspberry Pi 7" Touchscreen Housing or a 3D printed copy of it.
There is a relief on the bottom that lines up with a screw in the stock frame.
Prints without any support as long as you have your settings right fo
Mounts on the top of the Anet A8 with 3M VHB double sided tape, and upper section is built at an angle to mount the Official Raspberry Pi 7" Touchscreen Housing or a 3D printed copy of it.
There is a relief on the bottom that lines up with a screw in the stock frame.
Prints without any support as long as you have your settings right fo
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in