Thingiverse
NERDVille OctoPrint - FULLY Adjustable Camera + Light Rig
by NERDVille
239
Downloads
148
Likes
0
Makes
AT LAST, some quiet time enabled me to implement my own version of OctoPi for my Prusa i3 MK2
Unfortunately, this was specifically designed with my Prusa MK2 in mind but if you can redesign the Camera Stand v2 somewhere on your 3D printer, then I believe this can work just as well, just bear in mind that you will need to purchase the correct length camera ribbon. For Prusa this was a 1250 - 1500mm ribbon.
Refer to my photos so you can plan the cable length for this.
I would advise slightl
Unfortunately, this was specifically designed with my Prusa MK2 in mind but if you can redesign the Camera Stand v2 somewhere on your 3D printer, then I believe this can work just as well, just bear in mind that you will need to purchase the correct length camera ribbon. For Prusa this was a 1250 - 1500mm ribbon.
Refer to my photos so you can plan the cable length for this.
I would advise slightl
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in