Thingiverse
-Z Endstop Mount - Flyingbear P902
by BETLOG
40
Downloads
26
Likes
0
Makes
A somewhat more elegant and unobtrusive Z-endstop for Flyingbear P902.
...that also minimizes vibration and squeaking from the Z screw rod.
Use supports. There should only be one, and it will be trivial to pop out of the hole.
Layer height irrelevant, I used 0.2mm, PLA.
Two of the standard screws are replaced with longer ones for this (M3x16mm through the printer Z frame and this printed mount), and two (M3x20mm through the printed mount and the endstop switch) are added.
Also one M3 3
...that also minimizes vibration and squeaking from the Z screw rod.
Use supports. There should only be one, and it will be trivial to pop out of the hole.
Layer height irrelevant, I used 0.2mm, PLA.
Two of the standard screws are replaced with longer ones for this (M3x16mm through the printer Z frame and this printed mount), and two (M3x20mm through the printed mount and the endstop switch) are added.
Also one M3 3
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in