Thingiverse
Ormerod 2 Adapter to fit a Nimble V1
by ZestyTech
8
Downloads
5
Likes
1
Makes
An adapter and reworked E3D V6 mount for on the Ormerod 2 printer.
The adapter holds and centres the Nimble to the hot end and the two parts of the clamp allow for the V6 to be mounted. The rework of the clamps is just to add a bolt hole or a little space for a bolt to stick through the nut.
The Nimble will overhang at the back, roughly 9 mm. This should be OK and the holes for the tie-wraps are still usable.
To be able to print easier, I put a thin wall between the nut space and the bo
The adapter holds and centres the Nimble to the hot end and the two parts of the clamp allow for the V6 to be mounted. The rework of the clamps is just to add a bolt hole or a little space for a bolt to stick through the nut.
The Nimble will overhang at the back, roughly 9 mm. This should be OK and the holes for the tie-wraps are still usable.
To be able to print easier, I put a thin wall between the nut space and the bo
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in