Thingiverse
Undercarriage Fan Shroud for Lawsys New Carriage v2 - Solidoodle
by C_Cheetos
9
Downloads
6
Likes
0
Makes
Made an underside fan duct that fits Lawsy's NEW replacement carriages - centre front v2. i have an e3d v6 on my solidoodle, i dont know if it fits with another hot end.
It bothered me that the only fan duct out there was Lawsy's fan duct, which is made for a 30x30x5 mm fan, which is impossible to find. So i made one that can be adjusted to 30x30x7 or 30x30x10. (adjust to desired height using washers - see pictures).
i could not get it to print, so i made a stripped down version first, pr
It bothered me that the only fan duct out there was Lawsy's fan duct, which is made for a 30x30x5 mm fan, which is impossible to find. So i made one that can be adjusted to 30x30x7 or 30x30x10. (adjust to desired height using washers - see pictures).
i could not get it to print, so i made a stripped down version first, pr
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in