Thingiverse
Prusa i3MK2s fan duct advanced - "fiddler crab edition"
by Boby71
175
Downloads
99
Likes
4
Makes
*** Updated on 14th October 2018 - fiddler crab edition ***
Changes since last release:
- the left blower is now much, much bigger than before to improve cooling on the back side of the print.
- mount hole for the screw moved by -0,5mm in X and Z direction - now the fan duct fits absolutely perfect and level (before it was tilted by 2-3 degrees)
- added a small wall at the inlet where the fan sits for easier alignment and avoiding air to exit there
- some minor design flaws fixed in the CAD
Changes since last release:
- the left blower is now much, much bigger than before to improve cooling on the back side of the print.
- mount hole for the screw moved by -0,5mm in X and Z direction - now the fan duct fits absolutely perfect and level (before it was tilted by 2-3 degrees)
- added a small wall at the inlet where the fan sits for easier alignment and avoiding air to exit there
- some minor design flaws fixed in the CAD
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in