Thingiverse
Prusa Filament Out Sensor
by jmillerfo
71
Downloads
47
Likes
0
Makes
12/30/17 Update
This part supports Filament Out sensing directly by the Prusa Mini-Rambo 1.3a board. See section below for implementation. __Please note this requires a non-standard firmware load.__ This far I have not found any item supported by Prusa 3.1.0 firmware that this modified firmware does not support as well. This has the advantage of supporting Filament Out sensing when printing from the SD card as well as OctoPrint.
This **Prusa i3 MK2(S)** *Filament Run Out Sensor* detects
This part supports Filament Out sensing directly by the Prusa Mini-Rambo 1.3a board. See section below for implementation. __Please note this requires a non-standard firmware load.__ This far I have not found any item supported by Prusa 3.1.0 firmware that this modified firmware does not support as well. This has the advantage of supporting Filament Out sensing when printing from the SD card as well as OctoPrint.
This **Prusa i3 MK2(S)** *Filament Run Out Sensor* detects
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in