Thingiverse
Corner Brace Anet A8
by quirxi
22
Downloads
12
Likes
0
Makes
This is a corner brace for the Anet A8 printer to stabilize the frame in the z-axis.
It works really well - even without the screws in the front and sides.
For the front side I have used 3mm screws that were provided with the Anet A8 printer and for the side screw i have used 4mm screws and had to enlarge the hole in the frame a bit. The hole for the screws are a very tight fit - you really have to screw them in. If you dont like that you can change the diameter of the hole for the screw (in
It works really well - even without the screws in the front and sides.
For the front side I have used 3mm screws that were provided with the Anet A8 printer and for the side screw i have used 4mm screws and had to enlarge the hole in the frame a bit. The hole for the screws are a very tight fit - you really have to screw them in. If you dont like that you can change the diameter of the hole for the screw (in
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in