Thingiverse
Wanhao Duplicator 6 Blower Top & Duct
by JSpeed
34
Downloads
22
Likes
0
Makes
3/28/2021 Update:
Ok, Version 2.3 was practically unusable and not really much of an improvement anyway.
Here's version 2.4. All it really is, shortened the nozzle and added a bottom to it so it blows straight at the printer nozzle.
A cover on the heater block is highly recommended, or at least set your slicer to turn up the fan in steps. Probably both. Otherwise, the fan will cause a low temperature failure.
1/1/2018 Update: Well, Version 2.1 was a bust, but here's version 2.2
Exte
Ok, Version 2.3 was practically unusable and not really much of an improvement anyway.
Here's version 2.4. All it really is, shortened the nozzle and added a bottom to it so it blows straight at the printer nozzle.
A cover on the heater block is highly recommended, or at least set your slicer to turn up the fan in steps. Probably both. Otherwise, the fan will cause a low temperature failure.
1/1/2018 Update: Well, Version 2.1 was a bust, but here's version 2.2
Exte
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in