Thingiverse
Back cable protector
by VentusV
19
Downloads
7
Likes
0
Makes
edit 06.01.18:
- Uploaded v3 of the first design, made it longer because the bed cable sometimes went over its end towards the extruder and back over it during some large prints. It wouldnt tug on it but would push it bit by bit. So this is better. No "logo" anymore either.
Added a gcode i did in ideamaker with the model flipped over so it has minimal supports.
This is not essential but more of a piece of mind addon-mod for CR10.
I noticed that even with Strain Relief Upgrade (https:
- Uploaded v3 of the first design, made it longer because the bed cable sometimes went over its end towards the extruder and back over it during some large prints. It wouldnt tug on it but would push it bit by bit. So this is better. No "logo" anymore either.
Added a gcode i did in ideamaker with the model flipped over so it has minimal supports.
This is not essential but more of a piece of mind addon-mod for CR10.
I noticed that even with Strain Relief Upgrade (https:
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in