Thingiverse
RPI Camera housing
by memmop
80
Downloads
55
Likes
0
Makes
This is a simple housing for the Raspberry Pi Wide angle camera with IR LEDs.
The front will print without supports but the back will need them.
The back will snap onto the front but may need a little super glue to keep in.
The back has 2 round recesses for 2 x 8mm magnets so that camera can be magnetically mounted.
An arm is to follows to mount to my Bibo 2 Touch.
The front will print without supports but the back will need them.
The back will snap onto the front but may need a little super glue to keep in.
The back has 2 round recesses for 2 x 8mm magnets so that camera can be magnetically mounted.
An arm is to follows to mount to my Bibo 2 Touch.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in