Thingiverse
GoPro HERO Session 16° raised Wedge-mount
4
Downloads
3
Likes
0
Makes
A simple 16-degrees ascent to replace a foam wedge on miniquads.
It provides an imprint of the camera and therefore a better alignement for the GoPro HERO Session series (HERO/HERO4/HERO5).
The strap can run under the topplate as with classic foam wedge fittings or threaded through the slot if the wedge is attached to the top plate.
The position for the GoPro is raised to avoid the chance of propellers getting in the shot. Depending on the frame this should work up to 6 inch propellers. Sin
It provides an imprint of the camera and therefore a better alignement for the GoPro HERO Session series (HERO/HERO4/HERO5).
The strap can run under the topplate as with classic foam wedge fittings or threaded through the slot if the wedge is attached to the top plate.
The position for the GoPro is raised to avoid the chance of propellers getting in the shot. Depending on the frame this should work up to 6 inch propellers. Sin
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in