Thingiverse
EZ Brass Breech for Nerf Longshot Lipless Systems
114
Downloads
83
Likes
1
Makes
Lipless Brass Breech for the Nerf Longshot.
Fits 9/16 Brass tubes into the printed breech.
Original design by Flechette Spectre.
This particular support model has been tested using CFD and has shown to withstand 16kg of force on the support without failure (very far below failure level).
HOWEVER, computer simulation and real-life application differ at times, and I would not be responsible if you break anything.
V2 Changes made includes:
- Redesigned Fatigue supports. (stronger and
Fits 9/16 Brass tubes into the printed breech.
Original design by Flechette Spectre.
This particular support model has been tested using CFD and has shown to withstand 16kg of force on the support without failure (very far below failure level).
HOWEVER, computer simulation and real-life application differ at times, and I would not be responsible if you break anything.
V2 Changes made includes:
- Redesigned Fatigue supports. (stronger and
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in