Thingiverse
Canard Nose for GASB-1
by pauljs75
11
Downloads
8
Likes
0
Makes
An even longer nose section with a small LERX where it meets the other wing sections, and it has flat sides and a pass-through hole intended for a rod which links to canards.
Right now it's a WIP as it likely needs some revision (interior bits), but I figure this much is a start. Based partially on the revised nose section, but manually remeshed since some things are easier in Blender when working with quads instead of tris. On top of all that might have to split the nose piece into two sect
Right now it's a WIP as it likely needs some revision (interior bits), but I figure this much is a start. Based partially on the revised nose section, but manually remeshed since some things are easier in Blender when working with quads instead of tris. On top of all that might have to split the nose piece into two sect
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in