Thingiverse
Printrbot Simple Pro Wire Strain Relief with Camera Mount
by goofdad
8
Downloads
5
Likes
0
Makes
Broke the wires on my heatbed ... again ...
The clip goes on the front, the screws that tighten the X belt are used to secure the back. The bed wires are passed through the back trap and are zip tied in place.
The ball mount on the front is used to attach my camera mount (which should be posted tomorrow).
(yes, the printbed is off my printer in the pictures ... needed to repair the limit switch)
The clip goes on the front, the screws that tighten the X belt are used to secure the back. The bed wires are passed through the back trap and are zip tied in place.
The ball mount on the front is used to attach my camera mount (which should be posted tomorrow).
(yes, the printbed is off my printer in the pictures ... needed to repair the limit switch)
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in