Thingiverse
Prusa DIY Clone heated bed connector holder
by Gadjet0
6
Downloads
2
Likes
0
Makes
This is a holder for a heat bed connector, using a RC model battery connector.
This mounts to the centre tab of the Prusa clone bed carrier and allows the heat bed power cable and thermistor to be easily disconnected.
I also used Silicone coated cables as the connecting wires.
******Just added another version that screws in from above the heated bed mounting bracket, this means it's easier to remove the heated bed and bracket, it also has a recess to hold an M3 nut *********
This mounts to the centre tab of the Prusa clone bed carrier and allows the heat bed power cable and thermistor to be easily disconnected.
I also used Silicone coated cables as the connecting wires.
******Just added another version that screws in from above the heated bed mounting bracket, this means it's easier to remove the heated bed and bracket, it also has a recess to hold an M3 nut *********
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in