Thingiverse
Dremel 3D40 / 3D45 Rear Filament Holder
by Waggster
39
Downloads
28
Likes
2
Makes
A very simple removable filament holder for the rear of the 3D40 / 3D45 Idea Builder Dremel 3D Printer.
I used a 4mm drill for the four holes required. The filament bracket was first secured on then I ran the drill through the 45-degree tube hole to make sure I got the right position and angle.
You will also need around 200mm of 4mm tube for the filament and also 3 M3x15mm (ish) screws with washers and nyloc nuts.
TIP - I left the printer turned on and turned the lights down in the ro
I used a 4mm drill for the four holes required. The filament bracket was first secured on then I ran the drill through the 45-degree tube hole to make sure I got the right position and angle.
You will also need around 200mm of 4mm tube for the filament and also 3 M3x15mm (ish) screws with washers and nyloc nuts.
TIP - I left the printer turned on and turned the lights down in the ro
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in