Thingiverse
Duet Wifi Turbo Case
by cyllenius
31
Downloads
20
Likes
0
Makes
This is an enclosure for the Duet Wifi board.
FT5 Duet Wifi mount and Fan Duct by Garrett_w was the base for the mount, Honeycomb 120mm fan grill by Segeer was the base for the grid.
Under the enclosure put a 140mm fan in order to ensure a lot of cooling for the drivers.
I used M3 x 2 screws for assembling the cover, M4 x 4 screws and nuts for joining the enclosure to the fan below. M3 x 4 screws were used to jon the feet to the fan (the feet don't need nuts).
Feel free to remix and m
FT5 Duet Wifi mount and Fan Duct by Garrett_w was the base for the mount, Honeycomb 120mm fan grill by Segeer was the base for the grid.
Under the enclosure put a 140mm fan in order to ensure a lot of cooling for the drivers.
I used M3 x 2 screws for assembling the cover, M4 x 4 screws and nuts for joining the enclosure to the fan below. M3 x 4 screws were used to jon the feet to the fan (the feet don't need nuts).
Feel free to remix and m
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in