Thingiverse
CR-10S, OEM Fan, Offset Nozzle with Clip Clearance
by johnmcwGeo
23
Downloads
7
Likes
2
Makes
This is a remix of RickB's version of the fan nozzle.
Most of the fan nozzle replacements stick out too far below the existing and they hit the front clips too soon. This modification will clear from Y-10 on.
Printed at an angle to avoid supports, but used a brim at .40.
printed in PLA with 205c
Most of the fan nozzle replacements stick out too far below the existing and they hit the front clips too soon. This modification will clear from Y-10 on.
Printed at an angle to avoid supports, but used a brim at .40.
printed in PLA with 205c
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in