Thingiverse
Printrbot Smalls Legs
by ehud42
4
Downloads
1
Likes
0
Makes
Give your Smalls a wider stance!
The extended, heated, bed option causes the Smalls to wobble and the bed to hit the table, etc.
These legs give enough stance to prevent the printer from tipping.
They are 200mm long, so you'll probably need to a different printer to make them on. (or toss it into Tinkercad and cut it in half).
I made them fairly thick so that I could use the left of Plastite screws that came with the printer/upgrade.
One additional note: If screwing it in from the
The extended, heated, bed option causes the Smalls to wobble and the bed to hit the table, etc.
These legs give enough stance to prevent the printer from tipping.
They are 200mm long, so you'll probably need to a different printer to make them on. (or toss it into Tinkercad and cut it in half).
I made them fairly thick so that I could use the left of Plastite screws that came with the printer/upgrade.
One additional note: If screwing it in from the
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in