Thingiverse
GT2 Drive and Idler Pulley - w/Built in Bearings
137
Downloads
122
Likes
0
Makes
##3D Printed Timing Belt Set
20 tooth pulleys for a GT2 x 6mm wide timing belt I designed for a printer I am working on that is going to use as many 3D printed parts as possible.
##Drive Pulley
The drive pulley will fit a standard NEWA17 5mm diameter motor shaft with a 2mm flat. There is a hex nut trap for a 3mm set screw in the hub. The flange on one side of the pulley is at a 45 degree angle so it can be printed without supports.
##Idler Pulley
The idler pulley utilizes 12 standar
20 tooth pulleys for a GT2 x 6mm wide timing belt I designed for a printer I am working on that is going to use as many 3D printed parts as possible.
##Drive Pulley
The drive pulley will fit a standard NEWA17 5mm diameter motor shaft with a 2mm flat. There is a hex nut trap for a 3mm set screw in the hub. The flange on one side of the pulley is at a 45 degree angle so it can be printed without supports.
##Idler Pulley
The idler pulley utilizes 12 standar
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in