Thingiverse
Wanhao I3 Rear Mount for Original Fan Housing
by cgsnz
2
Downloads
2
Likes
0
Makes
Rear mount for the original fan housing for a Wanhao I3 v2.1.
Will need 2 20mm M4 screws for the bearing block and 2 8mm M3 screws to replace the fan housing's screws which are too short for this mount
Mounts on the lower x-axis linear bearing block. If your bearing blocks are plastic and have metal inserts for screws this should do for you. The lower bearing's bottom screw holes were empty on my printer, check that yours are also empty before printing.
Printed mine at .2mm layer thic
Will need 2 20mm M4 screws for the bearing block and 2 8mm M3 screws to replace the fan housing's screws which are too short for this mount
Mounts on the lower x-axis linear bearing block. If your bearing blocks are plastic and have metal inserts for screws this should do for you. The lower bearing's bottom screw holes were empty on my printer, check that yours are also empty before printing.
Printed mine at .2mm layer thic
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in