Thingiverse
JGAurora A5/A3S E3D V6 adaptation
by dcorcoles
61
Downloads
36
Likes
0
Makes
24/02/2019
Upgrade.
New piece, carriage without support for V6, to adapt it to other extruders, cyclops or similar type that can be anchored with 2 screws.
You only have to make the holes for the screws according to the model.
Replacement of the rear part of the printer carriage JGAurora A5 / A3S to adapt the E3D V6, as well as piece of attachment of the same and coupling of fan of layer.
An attempt has been made to make the piece and the coupling as close as possible to the ori
Upgrade.
New piece, carriage without support for V6, to adapt it to other extruders, cyclops or similar type that can be anchored with 2 screws.
You only have to make the holes for the screws according to the model.
Replacement of the rear part of the printer carriage JGAurora A5 / A3S to adapt the E3D V6, as well as piece of attachment of the same and coupling of fan of layer.
An attempt has been made to make the piece and the coupling as close as possible to the ori
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in