FrSky X-Lite cases for popular external module boards

Module cases for FrSky X-Lite radio.

Principle is:

- Print a module carrier, print finely (I used 0.15mm).
- Print the case and cover for your module (R9M, Banggood AVR 4-in-1, Banggood ARM 4-in-1 supplied), doesn't need to be fine (I used 0.25mm).
- Glue the carrier to the case with CA. The hole lets pass wires through.
- Make a wire harness with pin headers, pin order is the same on the X-Lite as on a JR module (see picture).
- Put some clear tape on the Xlite inside the module slot