Thingiverse
CR10 S5 glass holder block
by Bee69
33
Downloads
11
Likes
0
Makes
Hi Guys.
I made these so there is no gap and can not be over tightened and damage the glass. All that is needed is 6 30mm bolts and 6 T nuts. I've used two in the front and two in the rear plus one on ether side.
I made these so there is no gap and can not be over tightened and damage the glass. All that is needed is 6 30mm bolts and 6 T nuts. I've used two in the front and two in the rear plus one on ether side.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in