Thingiverse
Anet E12 Extruder Carriage Shroud
18
Downloads
11
Likes
0
Makes
This is a remix of a very nice x-axis carriage replacement I found. I've made some key differences over the original.
* Layer fan duct and nozzle lowered 3mm to blow closer to my nozzle tip
* Reduced the size of the wiring for the layer fan to a 3x3mm hole (leaks less air)
* Tucked the hole into the corner to stay away from the fan blades
* Made a larger opening to the right of the hotend heatsink to allow better cooling
* Dropped the arc that goes around the throat tube by 4mm to close
* Layer fan duct and nozzle lowered 3mm to blow closer to my nozzle tip
* Reduced the size of the wiring for the layer fan to a 3x3mm hole (leaks less air)
* Tucked the hole into the corner to stay away from the fan blades
* Made a larger opening to the right of the hotend heatsink to allow better cooling
* Dropped the arc that goes around the throat tube by 4mm to close
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in