Box Joint Jig Gears

These gears are for Matthias Wandel's box joint jig (woodgears.ca/box_joint/jig.html) as an alternative to cutting gears out of plywood.

12 and 16 tooth gears go on the active shaft of the jig. I added a drop of super glue between them and drilled 3 small holes for the prong T-nut to lock into the 16 tooth gear.

32 tooth gear goes with a handle on the top plane of the jig at 90 degrees to the 12/16 pair. Handle is held together with a M5 bolt and nut. You should either use a nylon nut or a